Archive for October, 2005

Exterior Nib Orig

Exterior Nib Orig

When painting with bright paint softer surface of his painting higher brightness can reach, in other words, you can prepare and paint a new door steel of the mark in exactly the same way as a wooden door, and could have done a perfect job and be very satisfied with the wooden door, but the steel door smoother have a higher brightness (due to the way light reflects) what this in mind that the smoother the surface paint better.

For this example I explain a spray paint steel door factory prepared.

Tools
1x 2.5ltr paint paint kettle
1x 1 "brush perfection Hamilton
1 x 2 "brush perfection Hamilton
Dusting brush 1x
1x bucket and sponge

Materials and Miscellaneous
Layer Trade
Trade brightness
Tack cloth (a sticky cloth when wiped and wiped on the surface collects dust and grit)
400 degrees of wet and dry paper abrasive
White spirit

The new insecticide prepared steel should be perfectly flat and smooth.

Step 1
Rub the surface lightly down prepared to provide a key and then remove dust with a dust brush.
Thin layer by about 5% and apply to door with 2 "brush and lay off the paint in one direction. Because the painting was diluted by the texture of the brush marks will be less noticeable than using pure tin.

Step 2
Rub lightly by any grain (edge) that can have on the surface of the bath and powder.

Step 3
Thin layer around the 5% and apply to door with 2 "brush painting and firing in one direction. Because the painting was diluted by the texture of the brush marks will be less alert able than using pure tin.

Step 4
Rub lightly by any grain (edge) that can be on the surface of the bath.

Step 5
Now get a bucket of water and dip into the bucket of a piece of 400 grade wet and dry paper and lightly rub the brush marks. The 400 degrees of being rather thin and in relation to water cuts out the brush marks and polish the surface to a very smooth base for brightness, when it is thoroughly rinsed with clean water and a sponge.

Step 6
Before the dust gloss and go over the surface with a tack cloth (available from the merchants of decoration), now ready to shine. Thin reduced brightness slightly around 5% for the paint to flow better and firing in one direction.

Step 7
Finally, the light tip from the surface, passing long with a tack cloth, then the brightness slightly slim down 5% for the paint to flow better and lay in one direction should now have a bright shiny door mild steel as you had to start after applying his paintings and took out the texture of brush marks with the wet and dry paper, and now applies the free-flowing brilliance to be the brush mark free.

If you apply the principles to get the surface as smooth as possible to begin by stripping, filling, and fade imperfections then apply the paint slightly diluted to a better flow and then rub with a fine paper texture of brush marks, can achieve higher quality gloss finishes to old surfaces painted wood as well.

The thinning of the relationship of painting is for good quality paint and painting trade not retail price or brand and that is thin.

I hope these are useful painting tips

@ Steve painting the interior

Hi this is Steve and I have been working in the decorating industry for 28 years, and I have started a web site to help people with their decorating, with whatever tips I can give.

http://www.interiorpaintdecorating.com